Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 7312) Press the button.f The command is fixed and ● is displayed at the left of the selected command.f After the command is fixed, press the button or the 13) Press as to select [STORE], and press the button.Notef When deleting commands that have already been set, press the button on the screen displayed in step 5).f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest commandnumber.f The operating time will be the local time. (x page 78)f If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in[SCHEDULE] is executed, the command set with this function may not be executed.[INITIAL STARTUP]Set the start up method when the switch is set to .1) Press as to select [INITIAL STARTUP].2) Press qw to switch [INITIAL STARTUP].f The items will switch each time you press the button.[LAST MEMORY] Starts the projector in the condition before the switch was turned .[STANDBY] Starts in standby.[ON] Starts projecting immediately.[STARTUP INPUT SELECT]Set the input when the projector is switched on to start projection.1) Press as to select [STARTUP INPUT SELECT].2) Press qw to switch [STARTUP INPUT SELECT].f The items will switch each time you press the button.[LAST USED] Keeps the input selected last.[COMPUTER] Sets the input to COMPUTER.[VIDEO] Sets the input to VIDEO.[DVI-I] Sets the input to DVI-I.[HDMI] Sets the input to HDMI.[DIGITAL LINK] Sets the input to DIGITAL LINK.
