Chapter 2 Getting Started — ConnectingENGLISH - 27 terminal pin assignments and signal namesOutside view Pin No. Signal name Pin No. Signal nameEven-numbered pins (2) to (18)(1) (19)(2) (18)Odd-numbered pins (1) to (19)(1) T.M.D.S data 2+ (11) T.M.D.S clock shield(2) T.M.D.S data 2 shield (12) T.M.D.S clock -(3) T.M.D.S data 2 - (13) CEC(4) T.M.D.S data 1+ (14) —(5) T.M.D.S data 1 shield (15) SCL(6) T.M.D.S data 1 - (16) SDA(7) T.M.D.S data 0+ (17) DDC/CECGND(8) T.M.D.S data 0 shield (18) +5 V(9) T.M.D.S data 0- (19) Hot plug detection(10) T.M.D.S clock+Connecting example: AV equipment'9'SOD\HUZLWK+'0,WHUPLQDO +'&39&5 ZLWKEXLOWLQ7%&%OXUD\GLVFSOD\HU$XGLRGHYLFHAttentionf Always use one of the following when connecting a VCR.g A VCR with built-in time base corrector (TBC)g A time base corrector (TBC) between the projector and the VCRf If nonstandard burst signals are connected, the image may be distorted. In such case, connect the time base corrector (TBC) between theprojector.f Use a commercial HDMI/DVI conversion cable with a ferrite core.Notef The terminal can be connected to HDMI- or DVI-I-compliant devices. However, images may not appear or may not be displayedproperly on some devices. (x page 61)f For an HDMI cable, use an HDMI High Speed cable that conforms to HDMI standards. If a cable that does not conform to HDMI standardsis used, images may be interrupted or not displayed, or the projector may not function properly.f The terminal of the projector can be connected to an external device with an DVI terminal by using an HDMI/DVI conversioncable, but some devices may not project the image properly or function properly. (x page 62)f When DVI-I is input, some external devices to be connected may require EDID to be set. (x page 61)f The projector does not support VIERA Link (HDMI).f If the [AUDIO IN SELECT] settings are incorrect, the projector may not output audio or otherwise function properly. (x page 77)
