Panasonic PT-RZ370E Operating Instructions Manual

Contents

Chapter 4 Settings — [PROJECTOR SETUP] menuENGLISH - 714) Press qw to switch [STANDBY MODE].f The items will switch each time you press the button.[ECO] Use this setting to reduce power consumption during standby.[NORMAL] Use this setting to use the network function during standby.Notef When set to [ECO], network functions are not available during standby. Also, some RS-232C commands are not available. When set to[NORMAL], network functions are available during standby.f If set to [ECO], there may be a delay in displaying when the power is turned on compared to when set to [NORMAL].Setting [ECO LEVEL DISPLAY]Display the power save level by the settings of [LIGHT POWER] and [AUTO POWER SAVE] as an illustration at the left bottom of theprojection screen.The more the number of green Leaf mark ( ), the more the power of the projector is saved.Screen display example:(&2/(9(/1) Press as to select [ECO MANAGEMENT].2) Press the button.f The [ECO MANAGEMENT] screen is displayed.3) Press as to select [ECO LEVEL DISPLAY].4) Press qw to switch [ECO LEVEL DISPLAY].f The items will switch each time you press the button.[OFF] Disables the ECO level display.[ON] Enables the ECO level display.Notef If a closed caption signal of the selected mode is input, the ECO level is not displayed.f The ECO level is not displayed when the menu screen is displayed.[SCHEDULE]Set the command execution schedule for each day of the week.Enabling/disabling the schedule function1) Press as to select [SCHEDULE].2) Press qw to switch [SCHEDULE].f The items will switch each time you press the button.[OFF] Disables the schedule function.[ON] Enables the schedule function. Refer to “How to assign a program” (x page 71) or “How to set aprogram” (x page 72) for how to set the schedule.Notef When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed.Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].How to assign a program1) Press as to select [SCHEDULE].2) Press qw to select [ON], and press the button.f The [SCHEDULE] screen is displayed.