Chapter 3 Basic Operations — Switching on/off the projector32 - ENGLISHIndicator status StatusOff The main power is switched off.RedFlashingThe power is switched off (in standby mode). [STANDBY MODE] is set to [NORMAL].Projection will start when the power <v/b> button is pressed.f The projector may not operate when the temperature indicator is flashing.(x page 108)LitThe power is switched off (in standby mode). [STANDBY MODE] is set to [ECO].Projection will start when the power <v/b> button is pressed.f The projector may not operate when the temperature indicator is flashing.(x page 108)Green Lit Projecting.Notef The projector consumes power even in standby mode (the power indicator lights/flashes in red).Refer to “Power consumption” (x page 122) for the power consumption.f The power indicator flashes in green if a remote control signal is received.f The power indicator flashes in green slowly when the projector is in AV mute mode.Switching on the projector1)3)2)3)1) Connect the power plug to an outlet.f (AC 100 V - 240 V 50 Hz/60 Hz)2) Press the side of the switch to turn on the power.f The power indicator lights/flashes in red, and the projector enters the standby mode.3) Press the power <v/b> button.f The power indicator lights in green and the image is soon projected on the screen.Notef If the projector is switched on at around 0 °C (32 °F), a warm-up period of approximately five minutes may be necessary until an image isdisplayed.The temperature indicator lights during the warm-up period. When the warm-up is completed, the temperature indicator turns off and the projection starts. Refer to “Managing the indicated problems” (x page 108) for the indicator status.f If the operating environment temperature is low and warm-up takes more than five minutes, the projector will judge that a problem hasoccurred and the power will automatically be set to standby mode. If this happens, increase the operating environment temperature to 0 °C(32 °F) or higher, turn off the main power, and then turn on the power again.f If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] (x page 70) is set to [ECO], there may be a delay indisplaying when the power is turned on compared to when the setting is [NORMAL].f When the power is turned or an input signal is switched, you may here a high-frequency driving sound. This is not a malfunction.f If the [PROJECTOR SETUP] menu → [INITIAL STARTUP] (x page 73) is set to [LAST MEMORY] and the power is turned off by pressingthe side of the switch or by using the breaker directly while projecting at the last time of use, the power indicator lights in green and projection starts after a while when the power is turned on by pressing the side of the switch with the power plug connected to the outlet, or when the breaker is turned on.