Chapter 4 Settings — Menu navigationENGLISH - 41Notef Pressing the button or the f Some items may not be adjusted or used for certain signal formats to be input to the projector. The menu items that cannot be adjusted orused are shown in gray characters, and they cannot be selected.f Some items can be adjusted even if signals are not input.f Individual adjustment screen is cleared automatically if no operation is performed for approximately five seconds.f For menu items, refer to “Main menu” (x page 41) and “Sub-menu” (x page 42).f The cursor color depends on the settings of the [OSD DESIGN] menu (x page 63). The selected item is displayed with the yellow cursorby default.Resetting adjustment values to the factory defaultIf the button on the remote control is pressed, the values adjusted in the menu items are restored to the factory default settings.button1) Press the button on the remote control.&2175$67$'-867Notef You cannot reset all the settings to the factory default at a time.f To reset all the settings adjusted in the sub-menu item to the factory default at a time, execute the [PROJECTOR SETUP] menu →[INITIALIZE] (x page 80).f Some items cannot be reset by pressing the button. Adjust each item manually.f The square mark under the bar scale in the individual adjustment screen indicates the factory default setting. The position of the squaremark varies by the selected input signals.&XUUHQWDGMXVWPHQWYDOXH)DFWRU\GHIDXOWVHWWLQJSetting the on-screen display to show/hideIf you press the displayed and the on-screen display can be set to show/hide.Notef If the [SECURITY] menu → [TEXT DISPLAY] is [ON], the on-screen setting screen cannot be displayed.Main menuThe main menu consists of the following 11 items.When a main menu item is selected, the screen changes to a sub-menu selection screen.Main menu item Page[PICTURE] 45[POSITION] 50[ADVANCED MENU] 54[DISPLAY LANGUAGE] 57[DISPLAY OPTION] 58[PROJECTOR SETUP] 68
