Chapter 4 Settings — [PROJECTOR SETUP] menu78 - ENGLISH[STATUS]Displays the status of the projector.1) Press as to select [STATUS].2) Press the button.f The [STATUS] screen is displayed.3) Press qw to switch the pages.f The page will change each time you press the button.[INPUT] Displays the input terminal currently selected.[SIGNAL NAME] Displays the input signal name.[SIGNAL FREQUENCY] Displays the frequency of the input signal.[PROJECTOR RUNTIME] Displays the operation times of the projector.[INTAKE AIR TEMP.] Displays the status of the air intake temperature of the projector.[OPTICS MODULE TEMP.] Displays the status of the internal temperature of the projector.[NUMBER OF ENTRYSIGNAL] Displays the number of registered signals.[EMULATE] Displays the [EMULATE] settings.[PROJECTOR TYPE] Displays the type of the projector.[SERIAL NUMBER] Displays the serial number of the projector.[MAIN VERSION] Displays the main version of the firmware of the projector.[SUB VERSION] Displays the sub version of the firmware of the projector.[NETWORK VERSION] Displays the network version of the projector.Notef The content of status can be sent via E-mail by pressing the button while displaying the status.[DATE AND TIME]Set the time zone, date, and time of the built-in clock of the projector.Setting time zone1) Press as to select [DATE AND TIME].2) Press the button.f The [DATE AND TIME] screen is displayed.3) Press as to select [TIME ZONE].4) Press qw to switch [TIME ZONE].Setting the date and time manually1) Press as to select [DATE AND TIME].2) Press the button.f The [DATE AND TIME] screen is displayed.3) Press as to select [ADJUST CLOCK].4) Press the button.f The [ADJUST CLOCK] screen is displayed.5) Press as to select an item, and press qw to set the local date and time.6) Press as to select [APPLY], and press the button.f The setting of the time will be completed.