Chapter 4 Settings — [NETWORK] menuENGLISH - 89[NETWORK SETUP]Perform the initial setting of the network before using the network function.1) Press as to select [NETWORK SETUP].2) Press the button.f The [NETWORK SETUP] screen is displayed.3) Press as to select an item, and change the settings according to the operation instructions of themenu.[PROJECTOR NAME] Change the setting when using a DHCP server.[DHCP] Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when notusing a DHCP server.[IP ADDRESS] Enter the IP address when not using a DHCP server.[SUBNET MASK] Enter the subnet mask when not using a DHCP server.[DEFAULT GATEWAY] Enter the default gateway address when not using a DHCP server.4) Press as to select [STORE], and press the button.5) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.Notef When using a DHCP server, confirm that the DHCP server is running.f Consult your network administrator regarding the IP address, subnet mask, and default gateway.[NETWORK CONTROL]Set up the control method of the network.1) Press as to select [NETWORK CONTROL].2) Press the button.f The [NETWORK CONTROL] screen is displayed.3) Press as to select an item, and press qw to change the setting.[WEB CONTROL] Set to [ON] to control with the web browser.[PJLink CONTROL] Set to [ON] to control with the PJLink protocol.[COMMAND CONTROL]Set to [ON] when controlling the projector with a terminal control command format(x page 119).Refer to “Control commands via LAN” (x page 115).[COMMAND PORT] Set the port number used for command control.[CRESTRON RoomView] Set to [ON] to control with RoomView of Crestron.[AMX D.D.]Set to [ON] to control with the controller of AMX.Setting this function to on enables detection with AMX device discovery. For details, refer to thewebsite of AMX.URL http://www.amx.com/[EXTRON XTP]Set to [ON] when connecting the “XTP transmitter” of Extron Electronics to the terminal.[EXTRON XTP] must be set to [OFF] when connecting an optional digital interface box (Model No.:ET-YFB100G).For details of “XTP transmitter”, refer to the website of Extron Electronics.URL http://www.extron.com/[STORE] Save the current network control settings.4) Press as to select [STORE], and press the button.5) When the confirmation is displayed, select [OK] or [CANCEL], and press the button.