Panasonic PT-RZ370E Operating Instructions Manual

Contents

Chapter 3 Basic Operations — Switching on/off the projectorENGLISH - 33Making adjustments and selectionsIt is recommended that images are projected continuously for at least 30 minutes before the focus is adjusted.3)2)1)2)1)4)1) Set the initial settings. (x page 17)f The initial setting screen is displayed when the projector is switched on for the first time after purchase as well as when [ALL USERDATA] (x page 80) in [INITIALIZE] is executed.2) Press the input selection (, ,

select the input signal. (x page 37)3) Adjust the front, back and sideway tilt of the projector with the adjustable feet. (x page 25)4) If the input signal is an RGB input signal, press the button. (x page 37)Switching off the projector1)3)2)4) 1) 2)1) Press the power <v/b> button.f The [POWER OFF(STANDBY)] confirmation screen is displayed.2) Press qw to select [OK], and press the button.(Or press the power <v/b> button again.)f Projection of the image stops.3) Wait for a few seconds until the power indicator of the projector body lights/flashes in red.4) Press the side of the

switch to turn off the power.Notef The projector consumes power if the main power of the projector is on, even when the power <v/b> button is pressed and thepower is switched off.When the [STANDBY MODE] menu (x page 70) is set to [ECO], the power consumption during standby can be conserved.f The power can be turned off by pressing the side of the

switch while projecting or by directly using the breakerunder conditions where the

switch of the projector cannot be switched off/on easily such as while mounting on the ceiling.However, the settings or adjustments performed right before the power is turned off may not be reflected.