5 – Non-Interactive Mode CommandsNon-interactive CommandsSN0054621-00 E 5-19A-linkchap(Assign a CHAP Entry to a Target)To link a CHAP entry to a target, enter the -linkchap command as follows:-linkchap <hba_port_inst> <CHAP No.> <Target ID>This command does not reset the HBA.For information on the interactive version of this command “Assign a CHAP Entryto a Target (CLI Option -linkchap)” on page 4-42.-lpThe IPv6 local prefix list is created based on prefix information from routeradvertisements. Destination IP addresses containing these prefixes can bereached directly, without going through an intermediate router.To display the local prefix list, enter the -lp command as follows:-lp <hba_port_inst>There is no corresponding interactive mode option for this command.-modelTo view the HBA “model(s)” (board type[s]) in the system, enter the -modelcommand as follows:-modelThere is no corresponding interactive mode option for this command.-n(Configure iSCSI Settings)To set to HBA iSCSI parameters for single port HBAs, enter the -n command asfollows:-n <HBA No.> <Config Name|Config Alias> <Value>[<Config Name|Config Alias> <Value> …]After you issue this command, the HBA is reset.You can repeat the <Config Name|Config Alias> <Value> parameter setfor as many parameters as you want to configure. Table 5-3 lists these parametersand their ranges of values.Table 5-3. HBA ParametersConfiguration Name Configuration Alias ValueAdd Firmware OptionsAFW_AutoConnect AFWAC on or off
