4 – Interactive Mode CommandsPort Level Info & Operations Menu4-20 SN0054621-00 ESDisplay Configured Link Configuration(CLI Option -lcd)Select the Display Configured Link Configuration option to view the followinginformation about the configured link:Portal Flow Control : (on or off)Auto-negotiate link speed: (on or off)Link Speed : (in Mbs)Configure Link Configuration(CLI Option -lc)Select the Configure Link Configuration option to view and modify each of theconfigurable link settings, including: Auto-negotiate link speed Flow ControlThe current setting (on or off) is shown in brackets. To change a setting, type onor off, and then press ENTER.Save Changes and Reset HBA (if necessary)Before resetting the HBA, ensure no connections are active. Select the SaveChanges and Reset HBA option to save your changes and reset all ports on theHBA.Port Network Settings MenuThe Port Network Settings Menu options include the following:1. Display Network Settings (see page 4-20)2. Configure IP Settings (see page 4-21)3. iSNS Settings (see page 4-21)4. Select HBA Port (see page 4-49)5. Save Changes and Reset HBA (see page 4-18)6. Refresh (see page 4-49)7. Exit (see page 4-50)Display Network Settings(CLI Options -netconf)Select the Display Network Settings option to view the settings for dynamic hostconfiguration protocol (DHCP), link local address, IPv6, and iSNS. For example:Using DHCP to obtain an IP Addresses.IPv4 Address : 10.14.65.19Gateway : 10.14.64.1Subnet Mask : 255.255.254.0
