5 – Non-Interactive Mode CommandsNon-interactive Commands5-12 SN0054621-00 ESYou can repeat the <Parameter>|<Parameter Alias> <Value> parameterpair to change multiple values as shown in Table 5-2. Press ENTER after eachentry.Issuing this command resets the HBA. For information on the interactive versionof this command, “Edit a CHAP Entry (CLI Option -edchap)” on page 4-43.-ei )To get information about errors and exit codes for non-interactive mode, enter the-ei command as follows (no parameters are required):-eiTo view a list of non-interactive mode errors, see “Non-interactive Mode ErrorCodes” on page D-5.-f(Update Firmware Image—Specific HBA)The firmware runs the tasks involved in data management, the iSCSI protocol,and general HBA functioning. Use the -f command to update the firmwareimage. For information on firmware file names, see Appendix E DownloadableFile Names.To update the HBA firmware from a specified file, enter the -f command asfollows:-f <hba_port_inst> <file name>Both parameters are required. The <hba_port_inst> is the HBA to update. The<file name> is the file containing the firmware image to upload to the HBA. Besure to use full path names. Issuing this command resets the HBA.For information on the interactive version of this command, see “Update FirmwareImage (CLI Option -f)” on page 4-13.-fa(Update Firmware Image—All HBAs)To update the firmware for all HBAs for which the image is appropriate, enter the-fa command as follows:Table 5-2. CHAP ParametersParameter Parameter Alias ValueCHAPName CNAME character stringCHAPSecret CSECRET character stringCHAPBidi CBIDI on or off
