4 – Interactive Mode CommandsPort Level Info & Operations MenuSN0054621-00 E 4-37A4. For each submenu, save the changes by typing the number for the SaveTarget/CHAP changes option, and then pressing ENTER.5. Type the number for the Refresh option, and then press ENTER. If you donot select this option, your changes will not be visible in SANsurfer iSCSIHBA CLI.List Targets(CLI Option -t)To list all targets connected to the current working adapter, type the number forthe List Targets option, and then press ENTER. The following information isdisplayed for each target: Target ID (target ID of this device as assigned by the QLogic tool) HBA number IP (IP address of the target) Port instance (port ID for iSCSI devices, as defined by the iSCSI standard) iSCSI name (target iSCSI name, as defined by the iSCSI standard) Alias (target iSCSI alias name, as defined by the manufacturer software) State (of the target session connection). Session states include: Unassigned No Connection Discovering Not Saved No Session Session Active Logged out Session Failed UnknownDisplay Target Information(CLI Option -t)Select the Display Target Information option to view the same informationshown for the List Targets option. At the Enter a Target ID: prompt, typethe ID of the target for which you want to see more detailed information, and thenpress ENTER.The following shows an example of target information:Target ID: 2 hba_no: 5 IP: 10.14.64.154 Port: 3260 TGT Instance #: 2ISCSI Name: iqn.1987-05.com.cisco:00.28182218624e.chap4Alias: chap4State: Session ActiveTGT_iSCSI_Name :iqn.1987-05.com.cisco:00.28182218624e.chap4TGT_Target_ID : 2(*)
