5 – Non-Interactive Mode CommandsNon-interactive CommandsSN0054621-00 E 5-25A-ping(Ping Target)To ping the target device specified IP address, enter the -ping command asfollows:-ping <hba_port_inst> <IP Address> <Ping Count> <Packet size><IPv6 source address>The following provides the IPv6 source address values:Where:For information on the interactive version of this command, see “Ping Target (CLIOption -ping)” on page 4-30.-psTo view persistent targets for the HBA port, enter the -ps command as follows:-ps [Target ID]If you do not specify the [Target ID], SANsurfer iSCSI HBA CLI displays alltargets for the specified HBA port number. If you do not specify the port instance[hba_port_inst] nor the Target ID, [Target ID], SANsurfer iSCSI HBA CLIdisplays all target IDs for all HBA ports in the system.There is no interactive command for this function.-puTo unbind a persistent target, enter the -pu command as follows:-pu <Target ID>0 = Do Not Care1 = Local Link2 = Address 03 = Address 1hba_port_inst = The HBA port that sends the ping.IP Address = The IP address to pin.Ping Count = The number of ping packets you want (1–[2^31]).Packet Size = The size of the ping packet 0-64kBIPv6 SourceAddress= Origin device
