5 – Non-Interactive Mode CommandsNon-interactive Commands5-6 SN0054621-00 ESFor a list of HBA settings, see Table 5-3 on page 5-19. For a complete list of HBAparameters, see Appendix C Target Parameters.For information on the interactive version of this command, see “HBA Information(CLI Option -ch)” on page 4-12.-chapmap(Display Targets Using CHAP Entries)To display the map of targets to CHAP table entries, enter the -chapmapcommand as follows:-chapmap For information on the interactive version of this command, see “Display TargetsUsing CHAP Entries (CLI Option -chapmap)” on page 4-41.-cpbootcode(Clear Primary Boot Target Information)To clear the primary boot target and LUN, enter the -cpbootcode command asfollows:-cpbootcode For information on the interactive version of this command, see “Clear PrimaryBoot Target Information (CLI Option -cpbootcode)” on page 4-36.-csbootcode(Clear Secondary Boot Target Information)To clear the secondary boot target and LUN, enter the -csbootcode commandas follows:-csbootcode For information on the interactive version of this command, see “Clear SecondaryBoot Target Information (CLI Option -csbootcode)” on page 4-36.-d(Install HBA Driver, All Adapters)To install an HBA driver for all iSCSI HBAs on the system from a .zip or .inffile, enter the -d command as follows:-d <File Name>A system reboot may be required; see the log file for details.NOTE:This command is not active for the PPC.
