5 – Non-Interactive Mode CommandsNon-interactive Commands5-8 SN0054621-00 ES-dfTo view the firmware properties, enter the -df command as follows:-df SANsurfer iSCSI HBA CLI displays information about the HBA: model, serialnumber, port number, iSCSI name, alias, IP address, instance number, and thefollowing firmware information: FW information for instance FW version FW attribute FW version 2 FW attribute 2There is no corresponding command in the interactive menu.-dpUse the -dp command to pre-install an HBA driver specified from a .zipor .inf file. This operation may be performed without an HBA installed in thesystem.You can specify the following actions: p — Pre-install driver package (default) i — Install driver package u — Uninstall driver package g — Get driver package pathYou may also specify the following flags: DRIVER_PACKAGE_FORCE DRIVER_PACKAGE_LEGACY_MODE DRIVER_PACKAGE_ONLY_IF_DEVICE_PRESENT DRIVER_PACKAGE_REPAIR DRIVER_PACKAGE_SILENTYou may need to reboot the system following this command. For details about thesuccess or failure of the driver update operation, view the trace log file (seeAppendix F Using Trace).-dr(Display Default Router List [IPv6 only])The IPv6 default router list includes both the active default router and a short listof other routers that advertised themselves as capable of acting as a defaultrouter. The active default router always appears first in the list.To view the default router list, enter the -dr command as follows:
