4 – Interactive Mode CommandsHBA Level Info & Operations Menu (CLI Option -i)4-12 SN0054621-00 ESHBA Level Info & Operations Menu(CLI Option -i)The HBA Level Info & Operations Menu provides the following options for eachHBA port instance:1. HBA Information (see page 4-12)2. HBA Options Menu (see page 4-13)3. HBA Reset (see page 4-14)4. HBA Diagnostic Menu (see page 4-15)5. HBA Level Parameters Menu (see page 4-17)6. Display VPD Information (see page 4-18)7. Select HBA Port (see page 4-49)8. Refresh (see page 4-49)9. Exit (see page 4-50)On each submenu, save the changes by typing the number for Save changesand reset HBA, and then pressing ENTER. This saves your changes and resetsall ports on the HBA.To update the firmware with these changes, type the number for Refresh, andthen press ENTER. If you do not select this option, your changes will not be visiblein SANsurfer iSCSI HBA CLI.HBA Information(CLI Option -ch)When you select the HBA Information option, information is listed for the workingadapter; for example:Board Type : QLE4060CChip Model : ISP4032Chip Version : 0Serial Number : QS40620A00034MAC Address : 00-C0-DD-08-97-40Driver Version : 2.1.4.18 (STOR w32)Firmware Version : 3.0.1.45ROM Version : 1.0.0.0iSCSI Version : 0.20BIOS/UEFI Version : 1.00BIOS/UEFI Full Version : 1.00
