5 – Non-Interactive Mode CommandsNon-interactive CommandsSN0054621-00 E 5-5AWhere:If HBA DHCP is enabled (see “-ipdhcp (Configure IP Settings)” on page 5-16),modes 1–3 are allowed. If HBA DHCP is not enabled, bootcode DHCP is notallowed. This mode is not supported for QLA4010 HBAs. This mode is not activefor the PPC.For IBM cards, the following modes are available:For information on the interactive version of this command, see “Set BIOS/UEFI[or FCode] Mode (CLI Option -bootcodemode)” on page 4-35.-c(Display Configured Port Settings)To view the configured settings for the port, enter the -c command as follows:-c [hba_port_inst]When you specify a port instance, information for only that HBA is shown. Whenyou do not specify a port instance, information for all HBA ports in the system isshown.For a list of HBA settings, see “Display Configured Port Settings (CLI Option -c)”on page 4-22 and Appendix C Target Parameters.-ch(HBA Information)To display the HBA’s configured settings, enter the -ch command as follows:-ch [hba_port_inst]When you specify a port instance, information for only that HBA is shown. Whenyou do not specify a port instance, information for all HBA ports in the system isshown.1 = Disabled2 = Manual mode3 = DHCP–Root path4 = DHCP Vendor ID5 = DHCP-Auto6 = Auto7 = System ModeNOTE:Bootcode DHCP is not allowed for QLA4010 HBAs.
