4 – Interactive Mode CommandsPort Level Info & Operations Menu4-40 SN0054621-00 ESAdd a Target(CLI Option -pa)Select the Add a Target option to add a new target to the current working adapter.When prompted, type the following information for the new target; the parametersare displayed one at a time: TGT_iSCSI_Name (target iSCSI name) TGT_Port (target port) TGT_TargetIPAddress (target IP address)If you do not enter the TGT_iSCSI_Name, the default is an empty string. If you donot enter the TGT_Port number, the default is 3260.Disable a TargetSelect the Disable a Target option to disconnect the target and disable futureconnections until you re-enable it. The target remains in the HBA database.Enable a TargetSelect the Enable a Target option to re-enable the target and re-establish theconnection, if possible.Configure Target Authentication MenuThe iSCSI HBA firmware uses the challenge handshake authentication protocol(CHAP) as an authentication mechanism between the iSCSI initiators (QLA4xxxHBA ports) and the targets to which they are attached. Authentication can bedisabled or enabled for a specific target or for all targets attached to the QLA4xxxHBA port.To configure target authentication (CHAP):1. If you have not already, specify the HBA port whose settings you want toview or change by typing the number for Select HBA Port, and thenpressing ENTER.SANsurfer iSCSI HBA CLI lists all iSCSI HBA ports.2. Type the number for the HBA port whose settings you want to change, andthen press ENTER.
