SN0054621-00 E 2-12 Installation and RemovalThis section provides procedures for the following: “Installing SANsurfer iSCSI HBA CLI” on page 2-1 “Removing SANsurfer iSCSI HBA CLI” on page 2-12Before you can run SANsurfer iSCSI HBA CLI, ensure that your system meets thefollowing requirements: HBAs are installed. HBA drivers are installed. To install SANsurfer iSCSI HBA CLI, the PC hard disk must have about 1MB free space.Installing SANsurfer iSCSI HBA CLIThis section on SANsurfer iSCSI HBA CLI installation includes the followinginformation: “Downloading the Installation Package” on page 2-1 “Installing on Microsoft Windows” on page 2-4 “Installing on Red Hat/SUSE Linux/PPC” on page 2-10 “Installing on Solaris SPARC/Solaris x86” on page 2-10Downloading the Installation PackageFollow the procedure in this section to download the SANsurfer iSCSI HBA CLIinstallation package from the QLogic Web site.To download the installation package:1. From the QLogic home page (www.qlogic.com), click Downloads.2. Select your HBA.NOTE:SANsurfer iSCSI HBA CLI is designed to configure QLogic HBAs on thelocal machine (where it is installed). It cannot configure HBAs on remotemachines.
