4 – Interactive Mode CommandsPort Level Info & Operations Menu4-34 SN0054621-00 ESFW Boot time = Mon Apr 23 17:08:56 2007BIOS/UEFI [or FCode] Settings MenuSANsurfer iSCSI HBA CLI detects the system architecture and shows this menuas either BIOS/UEFI Settings Menu or FCode Settings Menu, depending onyour system. On Intel type machines, the BIOS/UEFI Settings Menu appears; onPPC and SPARC, the FCode Settings Menu appears.To edit the HBA BIOS/UEFI or FCode settings:1. From the PORT BIOS/UEFI Settings Menu or PORT FCode SettingsMenu, specify the HBA port whose settings you want to view or change bytyping the number for Select HBA Port, and then pressing ENTER.SANsurfer iSCSI HBA CLI lists all iSCSI HBA ports.2. Type the number for the HBA port whose settings you want to change, andthen press ENTER.3. Select the following submenus to view or make changes to the HBAbootcode settings:1. Display BIOS/UEFI [or FCode] Information (see page 4-35)2. Set BIOS/UEFI [or FCode] Mode (see page 4-35)3. Set Primary Boot Target Information (see page 4-35)4. Set Secondary Boot Target Information (see page 4-35)5. Clear Primary Boot Target Information (see page 4-36)6. Clear Secondary Boot Target Information (see page 4-36)7. Set Alternative Client ID (see page 4-36)8. Save changes (see page 4-18)9. Select HBA Port (see page 4-49)10. Refresh (see page 4-49)11. Exit (see page 4-50)4. For each submenu, save the changes by selecting Save changes option.This saves your changes and resets all ports on the HBA.5. You must select Refresh to update the firmware with these changes andmake them visible in SANsurfer iSCSI HBA CLI.NOTE:If the BIOS version is less than 1.04, the Set BIOS/UEFI Mode option is notsupported (an error message is shown).
