5 – Non-Interactive Mode CommandsNon-interactive CommandsSN0054621-00 E 5-15AThe following shows an example of how the HBA port information might appear:0. HBA 0 Port: 0 HBA Port Instance: 0 HBA Model: QLA4050CHBA Serial Number: FS20525B03135 FW Version: 2.2.4.45 Type: CopperIP Address: 192.168.3.7Alias:iSCSI name: iqn.2000-04.com.qlogic.fs10506a02810.11. HBA 1 Port: 0 HBA Port Instance: 1 HBA Model: QLA4062CHBA Serial Number: AS40637A04673 FW Version: 3.0.1.18 Type: CopperIP Address: 192.168.3.22Alias:iSCSI name: iqn.2000-04.com.qlogic.as10506a02810.12. HBA 1 Port: 1 HBA Port Instance: 2 HBA Model: QLA4062CHBA Serial Number: AS40637A04673 FW Version: 3.0.1.18 Type: CopperIP Address: 192.168.3.38Alias:iSCSI name: iqn.2000-04.com.qlogic.as10506a02810.13. HBA 2 Port: 0 HBA Port Instance: 3 HBA Model: QLA4010HBA Serial Number: FS20407B03135 FW Version: 3.0.1.17 Type: CopperIP Address: 192.168.3.72Alias:iSCSI name: iqn.1991-05.com.microsoft.steinway.qlogic.orgFor information on the interactive version of this command, see “List All QLogiciSCSI HBA Ports Detected (CLI Option -i)” on page 4-48.-import(Import HBA Configuration)To import an HBA configuration from a file (see “-save (Save Host Configuration)”on page 5-28), enter the -import command as follows:-import <hba_no_target> <hba_no_Source> [A] [F N I T C B] <FileName>Where:<hba_port_inst> = The specific HBA to which the data is written<hba_port_inst_source>= The file with the HBA configuration you want.A = Configure all imported parameters (F, N, I, T, C, B).F = Configure the firmware.N = Configure the network parameters.
