5 – Non-Interactive Mode CommandsNon-interactive CommandsSN0054621-00 E 5-3ANon-interactive CommandsThis section contains an alphabetical list of the SANsurfer iSCSI HBA CLIcommands used in non-interactive mode.-acbTo inquire whether the ACB (access method control block) firmware functions aresupported, enter the -acb command. In general, up-to-date firmware and driverare required for ACB to be supported.-addchap(Add a CHAP Entry)To add a CHAP entry to the persistent CHAP table, enter the -addchapcommand as follows:-addchap [-BIDI] <CHAP Name> <CHAP Secret>The optional parameter [-BIDI] shows that the CHAP entry is BIDI(bidirectional). When this parameter is not specified (default), the CHAP entry islocal.Issuing this command resets the HBA. For more information on CHAP and theinteractive version of this command, see “Add a CHAP Entry (CLI Option-addchap)” on page 4-42.-arp(Display ARP Table)The Address Resolution Protocol (ARP) cache keeps a record of host portconnections with other hardware (such as targets) on the network. The IPaddress/MAC address pairs are dynamic entries that are removed after 10minutes. To view the ARP table, enter the -arp command as follows:-arp For information on the interactive version of this command, see “Display ARPTable (CLI Option -arp)” on page 4-32.-b(HBA Reset)To reset the specified HBA after making configuration changes, enter the -bcommand as follows:-b
