142 Part F: Configuring Channels © Tait Electronics Limited December 2007Selecting a ChannelAfter you have set up a number of channels, you need to specify the one thatthe base station will actually operate on.1. Select Configure > Base Station > General.2. In the Default channel box, choose a channel from the drop-down list.This is the channel that the base station will operate on, unless it uses exter-nal channel selection or a Task Manager action changes channel or makes adifferent channel the default.Note: After you change channel or re-configure channels, the basestation may not start operating on the correct channel while still inStandby mode. Change to Run mode, and it will operate on thecorrect channel as configured.
