62 Part C: Basic Tasks © Tait Electronics Limited December 20077. Click Enable. This enables the feature set. The license key appears in thefeature set’s row and the Seq column is incremented by 1.Disabling a Feature SetFeature sets are not normally disabled. However, disabling may be desirable inspecial circumstances, for example, if you are trying out the feature set anddecide not to purchase it.Disabling the Alarm Reporting Feature SetYou can only disable this feature set if the base station does not use it.Important: A disabled feature set can only be re-enabled bypurchasing a new license key. The original feature license keycannot be re-used.1. Check the Reciter Serial Number box to make sure that you are loggedon to the correct base station.2. Make sure that communications with the Alarm Center (Configure >Communications > Alarm Center) and communications using email(Configure > Communications > Email) are disabled.3. Go into Standby mode.4. Select Tools > Software Feature Enabler.5. Select the feature set’s row.6. Click Disable.The progress bar indicates how far the disabling has progressed. Oncompletion, a new number appears in the Feature License Key column.Communicate this new number to Tait if you are entitled to a refund or ifyou want to re-enable the feature set.Disabling the Advance Profiles and Task Manager FeatureSetYou can only disable this feature set if the base station does not use it.Important: A disabled feature set can only be re-enabled bypurchasing a new license key. The original feature license keycannot be re-used.1. Check the Reciter Serial Number box to make sure that you are loggedon to the correct base station.2. Make sure that no channels use customized channel or signalling profiles. (Inother words, they all use default profiles.)3. Make sure that there are no more than 20 enabled task manager tasks.Thenumber of enabled Task Manager tasks is displayed in all Task Managerforms. If necessary, disable unneeded tasks until the total number is 20 orless.4. Go into Standby mode.5. Select Tools > Software Feature Enabler.6. Click the feature set’s row.7. Click Disable.
