198 Part I: Task Manager © Tait Electronics Limited December 2007External channel select enabledThe override input External channel select enabled becomes true whenTask Manager sets the H/W channel select flag. This occurs on entering Runmode and if a Task Manager task enables power saving after a previous task hasdisabled it.ExampleIF NOT External channel select enabled THEN Go to channel 2This example specifies the channel that the TB8100 will operate on if a TaskManager action disables external channel selection. This is another way ofspecifying the channel in software; you can also select a channel as the default.Syslog service enabledThe override input Syslog service enabled becomes true when Task Managerturns the Syslog service system flag on. This occurs on entering Run mode andif a Task Manager task enables the syslog service after a previous task hasdisabled it. When the syslog service system flag is on, the base station sendssyslog messages according to the configuration in Configure >Communications > Syslog.Power saving enabledThe override input Power saving enabled becomes true when TaskManager turns the Power save system flag on. This occurs on entering Runmode and if a Task Manager task enables power saving after a previous task hasdisabled it.Timer expiredA timer can only be started by the Task Manager action Start timer. It expireswhen the timer’s maximum time has elapsed. This time was entered inConfigure > Task Manager > Timers.ExampleIF Timer expired (Weekly Email) THEN Email status now.This input can be used to set up regular actions such as emailing the statusmessage.Tx relay enabledThe override input Tx relay enabled becomes true when Task Manager turnsthe Tx relay system flag on. This occurs on entering Run mode and if a TaskManager task enables power saving after a previous task has disabled it.Channel Profile InputsChannel profile inputs relate to configuration items that are defined in channelprofiles. You can put tasks with a channel profile input into the folder for aparticular channel profile or into the General folder. If the task is in a channelprofile folder, it is only processed when the current channel uses that profile. Itthe task is in the General folder, it is always processed.
