TB8100 Service Kit User’s Manual Task Manager Inputs and Actions 213When the flag is enabled, CWID is transmitted as configured in the channelprofile’s CWID System tab.If the channel profile does not provide for CWID, this flag has no effect.Transmit CWID nowThe ‘do now’ action Transmit CWID now instructs the base station toimmediately transmit the CWID message defined in the CWID System tab.This action enables you to configure CWID transmissions in a way that is nototherwise possible. For example, you could have the CWID transmitted morethan once a minute or at every transmit tail.Transmit CWID now works even if a CWID action has disabled the CWIDsystem flag.Transmitter power override actionsTask Manager can override the normal transmit power level and instruct the PAto use a special power level. This action can be used to reduce the transmitpower if the DC input level is low or to increase the transmit power when thereceived signal strength is low. If the base station is transmitting when thetransmit power is changed, there will be a short interruption to the transmission.The system flag Transmit power override indicates the current status. If it isenabled, Task Manager has overridden the configured transmit power level.The special power level is set by the Task Manager override box (in the channelprofile, General tab).When the base station enters Run mode, Task Manager clears any transmitpower override. The normal transmit power level is used.When Task Manager enables the transmit power override, the PA uses the TaskManager override transmit power level.When Task Manager disables the transmit power override, the PA reverts tousing the normal transmit power level, as defined by the current channel profileor the channel table.ExampleIF Battery voltage low THEN Enable transmitter power overrideIF NOT Battery voltage low THEN Disable transmitter power overrideSignalling Profile ActionsSignalling profile actions relate to configuration items that are defined insignalling profiles. You can put tasks with a signalling profile action into thefolder for a particular signalling profile, or into the General folder. If the task isin a signalling profile folder, it is only processed when the current channel usesthat profile. If the task is in the General folder, it is always processed.Subaudible DecodingSubaudible decoding override actions can enable, disable, or toggle theSubaudible decode system flag. This gives you an extra layer of control over thebase station’s response to subaudible signalling.When the base station enters Run mode, the flag is enabled.When the flag is enabled, any subtones are decoded and checked against thecurrent signalling profile. A received signal is only valid if it contains a specifiedsubtone.
