System Settings103Receiving Buffer - Port 9100Specifies the input buffer memory capacity for Port 9100 interface within the range of64-1024 KB in 32 KB increments using the scroll buttons or the numeric keypad. Thecurrently available memory will be displayed at the top of the screen with the followingmessage: “Memory Available: XXX MB.”Other SettingsThis feature allows you to specify a printable area and replacement method whenpaper runs short.1. Select [Other Settings] in the[Features] menu.2. Change the required settings.Use the scroll buttons to switchbetween screens.3. Select [Close].Print AreaSpecifies the printable area. Select [Standard] to crop a margin 4.1 mm (0.16 inches)wide along all four edges of the paper. Select [Extended] to crop a margin of 2 mm (0.08inches) along the edges.Substitute TraySpecifies the substitute tray when the machine cannot detect the paper traycorresponding to the document size with the auto paper selection.• Display MessageSpecifies a message prompt requesting paper supply be displayed withoutswitching paper trays.• Use Larger SizeSpecifies switching to the tray loaded with the next larger size of paper and printsthe document in its original size.• Use Closest SizeSpecifies switching to the tray loaded with the paper in the size closest to theselected paper. Image size may be automatically reduced as required.NOTE: A job sent from a computer takes priority over a job instigated on the machine.• Select Tray 5 (Bypass)Specifies switching to the bypass tray.Paper Type MismatchSpecifies whether to print, display the confirmation screen, or display the paper supplyscreen when a paper type mismatch occurs.Unregistered FormsSpecifies whether to abort a job which is specified to use form overlay when a form isnot found (not registered) in the machine.
