Network-related Problems373However, if the machine is switched off immediately after a print request, the printdata may be stored on the client. In this case, the print request can be reissued whenthe machine is switched on, and the print data is printed on the machine.When printing• When [Receiving Buffer - LPD] is set to [Spool to Hard Disk] or [Spool to Memory]:Print data cannot be received if the print data size exceeds the available capacity ofthe hard disk or memory allocation.NOTE: If the print data exceeds the receiving buffer capacity, the client may retransmitthe same print data. In this case, stop the client and make sure that the client does nottransmit the print data.• When [Receiving Buffer - LPD] is set to [No Spooling]:Print requests cannot be received from a client if a print request from another clientis being processed.• When the client IP address or computer name is changed:When the client IP address or computer name is changed, the machine cannotperform query processing and cancel processing. Switch the machine off and onwith the receiving buffer empty of print data.NOTE: Stopping printing or forced deleting of print data in the machine receivingbuffer can be performed using the control panel. For information, refer toJob Statuson page 39EtherTalkThis section explains the troubleshooting procedures and restrictions while usingEtherTalk.TroubleshootingThe possible causes, confirmation methods, and actions are as follows.Problem Cause ActionA job was printed on adifferent machine than theassigned machine.If there are multiple machineson the network with the samename, the machine namesare changed automaticallydepending on the power-ontiming of each machine. Printjobs intended to be printed onone machine are sent toanother machine.Change the machine namesso that all machine names onthe network are unique.The machine cannot beaccessed from a client.The machine name, used bythe client to recognize themachine, cannot beregistered if the machine isswitched on when notconnected to the network.Switch on the machine afterconnecting to the network. Ifthe machine is switched onwhen not connected to thenetwork, switch off themachine, connect to thenetwork, and switch on themachine again.
