Internet Fax Installation289Test Internet FaxAn Internet Fax job should be submitted to make sure that the machine has beeninstalled and configured correctly.Network Communication SetupNOTE: Some of the configuration options for this protocol are only available fromCentreWare Internet Services. Refer toCentreWare Internet Services on page 147.NOTE: Keep the SNMP port enabled while you use the machine on the TCP/IPnetwork.Initially, activate the port.1. Connect the machine to the network.2. Press the button on the control panel, and then type the SystemAdministrator login ID to enter the System Administration mode.NOTE: The passcode may also be required depending on the machine configuration.3. Press the button on the control panel, and then select the[Tools] tab on the screen.4. Select [System Settings] in the menu at the left side of the screen.5. Select [Connectivity & Network Setup] in the [Group] menu.6. Select [Port Settings] in the [Features] menu.7. Select [Receive E-mail] and then [Change Settings].8. Select [Port Status] and then [Change Settings].9. Select [Enabled] and then [Save].10. On the [Port Settings] screen, select [Send E-mail] and then [Change Settings].11. Select [Port Status] and then [Change Settings].12. Select [Enabled] and then [Save].Next, establish TCP/IP.1. Select [Connectivity & Network Setup] in the [Group] menu, and then select[Protocol Settings] in the [Features] menu.2. Under [TCP/IP - IP Mode], select [IPv4 Mode], [IPv6 Mode], or [Dual Stack].When [IPv4 Mode] or [Dual Stack] is selected in step 23. Select [IP Address Resolution], and then [Change Settings].4. Select a method for establishing an IP address from [DHCP], [BOOTP], [RARP],[DHCP/Autonet], and [STATIC], and then select [Save].NOTE: Use the DHCP server together with the Windows Internet Name Server(WINS) server.If you selected [STATIC] in step 4, then proceed to step 5 to configure the protocolsettings. Otherwise, proceed to step 11.5. Select [IPv4 - IP Address], and then [Change Settings].6. Use the keypad on the screen to enter an IP address for the machine in the format“xxx.xxx.xxx.xxx”. When you have finished entering all values, select [Save].
