Microsoft Networking251Test PrintTo make sure that the machine has been installed on the network correctly, a test printshould be submitted from each client computer. Perform the following steps.1. Open a sample document on a client computer.2. Select the machine using the Chooser (Mac OS 9.2) or the Print Center (Mac OSX 10.x).3. Print the document on the machine and verify that it prints correctly.4. Make sure that the driver is installed on every computer that will be sending jobsto the machine.5. Repeat the test for all computers that will be sending jobs to the machine.The installation process is now complete.If the test print fails, refer toProblem Solving on page 341.Microsoft NetworkingThis section explains how to set up the machine to operate on a Microsoft network. Thefollowing information is provided:Information Checklist – page 251SMB Environments – page 252SMB Installation – page 252Installation Procedure – page 252Network Communication Setup – page 253Computer Setup – page 255Test Print – page 255Information ChecklistBefore starting the Microsoft networking installation procedures, make sure that thefollowing items are available or have been performed.If problems are encountered during the installation, refer toProblem Solving onpage 341.Item ByAn existing operational Microsoft network is required. These proceduresare not designed to install a Microsoft network.CustomerObtain and record the following information, if required:• IP address• Gateway address• Subnet mask (for IPv4) / Prefix (for IPv6)• Host nameCustomerTest the machine to make sure that it is fully installed and functioningcorrectly.CustomerInstall the print driver. Customer
