USB Port259Test PrintTo make sure that the machine has been installed on the network correctly, a test printshould be submitted from each client computer. Perform the following steps.1. Open a document on a client computer.2. Select the machine as the printer to which the selected document will be sent.3. Print the document on the machine and verify that it prints correctly.4. Make sure that the driver is installed on every computer that will be sending jobsto the machine.5. Repeat the test for all computers that will be sending jobs to the machine.The installation process is now complete.If the test print fails, refer toProblem Solving on page 341.USB PortThis section explains how to set up the machine in a USB port environment. Thefollowing information is provided:Information Checklist – page 259USB Port Environment – page 260USB Port Installation – page 260Installation Procedure – page 260USB Port Communication Setup – page 260Computer Setup – page 261Test Print – page 261Information ChecklistBefore starting the USB port installation procedures, make sure that the following itemsare available or have been performed.NOTE: The installation procedures will install the machine on the USB port of the hostcomputer. The procedures are not intended to connect the host computer to othercomputers.If problems are encountered during the installation of the machine, refer toProblemSolving on page 341.Item ByUSB Cable CustomerTest the machine to make sure that it is fully installed and functioningcorrectly.CustomerInstall the print driver. Customer
