NetWare229Target computersThe NetWare versions and NetWare client computers require the followingenvironments.NetWare versionsA Novell-accredited computer which can be installed with NetWare 3.x/4.x/5.x/6.x.NetWare client computersA Novell-accredited computer which can run Windows 2000, Windows XP or WindowsServer 2003.NOTE: When using the LPD port by Novell Distributed Print Services (NDPS), activatethe LPD port on the machine and set the IP address.IPX/SPX frame typesThe machine supports the following Ethernet interfaces.• 10Base-T (Twisted Pair Cable)• 100Base-TX (Twisted Pair Cable)The machine supports the following frame types.• Ethernet II specification• IEEE802.3 specification• IEEE802.3/802.2 specification• IEEE802.3/802.2/SNAP specificationThe machine sends out packets of each frame type on the connected network. Itautomatically uses the frame type which corresponds to the first response. However, ifmore than one protocol is running simultaneously on the same network, the machinewill use the same frame type as used by the NetWare server.NOTE: Some network components, such as the hub, may not support automaticframe type setup. If the data link indicator light of the port does not light up, match theIPX/SPX setting of the frame type of the machine, to the frame type of the file server.NetWare InstallationThis section describes the installation procedures to use the machine in a NetWareenvironment.Installation ProcedureThe installation procedure is as follows.Network Communication SetupEnable the NetWare port.When using IPX:Set the Netware port to [Enabled] using the touch screen or CentreWare InternetServices.When using TCP/IP:Set the Netware port to [Enabled] using the touch screen or CentreWare InternetServices. Set the IP address on the control panel or CentreWare Internet Services.For more information, refer toNetwork Communication Setup on page 230.
