6 Setups68Fault ToneSpecifies the volume level of the tone generated when a job did not finish properly.Alert ToneSpecifies the volume level of the tone generated when a job is suspended due to anerror.Out of Paper Warning ToneSpecifies the volume level of the tone generated when the machine runs out of paper.Low Toner Alert ToneSpecifies the volume level of the tone generated when it is time to replace the tonercartridge.Line Monitor VolumeSpecifies the volume level of the tone generated for the line monitor, which allows youto hear call and response signals when connecting to a destination.Ringing VolumeSpecifies the volume level of the tone generated when a call is received.Stored Programming ToneSpecifies the volume level of the tone generated each time an operation is performedduring job memory registration. You cannot completely turn off the volume for this tone.Auto Clear Alert ToneSpecifies the volume level of the tone generated just before the machine performs autoclear.Base ToneSpecifies the volume level of the base tone generated when you toggle settings. Themachine emits a base tone when it exits the interrupted mode.Screen/Button SettingsThis feature allows you to customize the initial screen and select the initial language tobe displayed on the touch screen.1. Select [Screen/Button Settings]in the [Features] menu.2. Change the required settings.Use the side tabs to switchbetween screens.3. Select [Close].Screen Default at Power OnSpecifies the initial screen to be displayed when the machine is switched on. Set thepreset initial screen to the All Services, Job Status, or Machine Status screen. Forinformation on the Job Status and Machine Status screens, refer toJob Status on page39 and Machine Status on page 49.
