Loading PaperXerox WorkCentre 3315DN/3325DN/3325DNIUser Guide1452. Slide the paper length guide until it lightly touches theend of the paper stack.3. Position the side guide by squeezing the lever and slidingit towards the stack of paper, until it gently touches theside of the stack.4. Insert the paper tray into the machine.5. After loading paper in the paper tray, set the paper sizeand type using the control panel. Press OK to confirm thesettings or Stop to change the settings. These settingswill apply to Copy and Fax modes.6. When printing from your computer, ensure you select theSelect Paper button to specify the correct paper size,color and type. Not confirming the paper details mayresult in printing delays. For information about settingthe paper type and size on the control panel, refer toSetting Paper Size and Type on page 148.Note: The settings made from the printer driver on your computer override the settings on thecontrol panel.Using the Bypass TrayThe bypass tray is located on the front of your machine. It can be closed when not in use, making theproduct more compact. Use the bypass tray to print transparencies, labels, envelopes or postcards inaddition to making quick runs of paper types or sizes that are not currently loaded in the paper tray.When using the bypass tray for special media it may be necessary to use the rear door for the output.For further information refer to Media Output Locations on page 23.Acceptable print media is plain paper from 3.0 x 5.0 inches to 8.5 x 14 inches Legal (76 mm x 127 mmto 216 mm x 356 mm) and weighing between 16 lb and 58 lb (60 g/m² and 220 g/m²). For more mediaspecifications, refer to Media Specifications on page 150.
