Fax SetupXerox WorkCentre 3315DN/3325DN/3325DNIUser Guide166Fax SetupYour machine provides you with various user-selectable options for setting up the fax system. You canchange the default settings for your preferences and needs.Enable/DisableUse this option to enable or disable the Fax service:1. Press Machine Status on the control panel.2. Press the up/down arrows to highlight Fax Setup and press OK. If necessary, enter theAdministrator’s Password using the keypad. Refer to Accessing the Setup Options on page 154 forinstructions.3. Press the up/down arrows to highlight Enable/Disable and press OK.4. Press the up/down arrows to highlight Enabled or Disabled. Press OK.5. Press Stop to return to Ready mode.Sending1. Press Machine Status on the control panel.2. Press the up/down arrows to highlight Fax Setup and press OK.3. If necessary, enter the Administrator’s Password using the keypad. Refer to Accessing the SetupOptions on page 154 for instructions.4. Press the up/down arrows to highlight Sending and press OK.The following Sending options and settings are available:Note: * indicates the factory default setting.Option Description SettingsRedial Times You can specify the number of redial attempts. If youenter 0, the machine will not redial.• 0 - 13 Times7 *Redial Term Your machine can automatically redial a remote faxmachine if it was busy. You can set an interval betweenattempts.• 1 - 15 Minutes3 *Prefix Dial You can set a prefix of up to five digits. This numberdials before any automatic dial number is started.• Fax: (enter up to 5numbers to set theprefix)ECM (Error CorrectionMode)This mode helps with poor line quality and makes sureany faxes you send are sent smoothly to any otherECM-equipped fax machine. Sending a fax using ECMmay take more time.• On *• OffSend Report Enables or disables printing of a confirmation reportshowing whether the fax was successful or not.• On Error *• On• Off
