Setting Paper Size and TypeXerox WorkCentre 3315DN/3325DN/3325DNIUser Guide148Setting Paper Size and TypeAfter loading paper in the paper tray, set the paper size and type using the control panel. Thesesettings will apply to Copy and Fax modes. For computer printing, select the paper size and type in theapplication program you use on your computer.Note: The settings made from the printer driver on your computer override the settings on thecontrol panel.After closing the paper tray the Paper Size and Type settings are automatically displayed. If correct,use the settings displayed or follow the steps below to change the settings to match the Paper Size andType of paper loaded.Setting the Paper Size1. Press Machine Status on the control panel.2. Press the up/down arrows to highlight System Setup and press OK. If necessary, enter theAdministrator’s Password using the keypad. Refer to Accessing the Setup Options on page 154 forinstructions.3. Press the up/down arrows to highlight Paper Setup and press OK.4. Press the up/down arrows to highlight Paper Size and press OK.5. Press the up/down arrows to select the paper tray you want and press OK.6. Press the up/down arrows to select the paper size you want.7. Press OK to save the selection.8. Press Stop to return to Ready mode.If you want to use special sized paper, select a custom paper size in the Printer Driver. Refer to PaperOptions on page 105 for instructions.Setting the Paper Type1. Press Machine Status on the control panel.2. Press the up/down arrows to highlight System Setup and press OK. If necessary, enter theAdministrator’s Password using the keypad. Refer to Accessing the Setup Options on page 154 forinstructions.3. Press the up/down arrows to highlight Paper Setup and press OK.4. Press the up/down arrows to highlight Paper Type and press OK.5. Press the up/down arrows to select the paper tray you want and press OK.6. Press the up/down arrows to select the paper type you want.7. Press OK to save the selection.8. Press Stop to return to Ready mode.Setting the Paper Source1. Press Machine Status on the control panel.
