Fax RegulationsXerox WorkCentre 3315DN/3325DN/3325DNIUser Guide245Fax RegulationsUnited StatesThis device has been tested to and is compliant with FCC part 68, TIA-968-A and TIA-968-B.Fax Send Header RequirementsThe Telephone Consumer Protection Act of 1991 makes it unlawful for any person to use a computer orother electronic device, including a fax machine, to send any message unless such message clearlycontains in a margin at the top or bottom of each transmitted page or on the first page of thetransmission, the date and time it is sent and an identification of the business or other entity, or otherindividual sending the message and the telephone number of the sending machine or such business,other entity or individual. The telephone number provided may not be a 900 number or any othernumber for which charges exceed local or long distance transmission charges. In order to program thisinformation into your machine, refer to Machine Settings on page 170 for instructions.Data Coupler InformationThis device complies with Part 68 of the FCC rules and the requirements adopted by the AdministrativeCouncil for Terminal Attachments (ACTA). On the cover of this device is a label that contains, amongother information, a device identifier in the format US:AAAEQ##TXXXX. If requested, this numbermust be provided to the Telephone Company. A plug and jack used to connect this device to thepremises wiring and telephone network must comply with the applicable FCC Part 68 rules andrequirements adopted by the ACTA. A compliant telephone cord and modular plug is provided with thisdevice. It is designed to be connected to a compatible modular jack that is also compliant. Seeinstallation instructions for details.You may safely connect the machine to the following standard modular jack: USOC RJ-11C using thecompliant telephone line cord (with modular plugs) provided with the installation kit. See installationinstructions for details. To order the correct service from the local telephone company, you may alsohave to quote the codes listed below:• Facility Interface Code (FIC) = 02LS2• Service Order Code (SOC) = 9.0YWARNING: Ask your local telephone company for the modular jack type installed on your line.Connecting this machine to an unauthorized jack can damage telephone company equipment.You assume all responsibility and/or liability for any damage caused by the connection of thismachine to an unauthorized jack.The Ringer Equivalence Number (REN) is used to determine the number of devices that may beconnected to a telephone line. Excessive RENs on a telephone line may result in the devices not ringingin response to an incoming call. In most but not all areas, the sum of RENs should not exceed five (5.0).To be certain of the number of devices that may be connected to a line, as determined by the totalRENs, contact the local Telephone Company. The REN for this device is part of the device identifier thathas the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a decimal point(e.g., 03 is a REN of 0.3).
