Scan ProcedureXerox WorkCentre 3315DN/3325DN/3325DNIUser Guide48Document GlassThe document glass can be used for oversized, torn or damaged originals and for books andmagazines.1. Open the automatic document feeder and place singledocuments face down on the document glass alignedwith the rear left corner.2. The default document size is 8.5 x 11” or A4. For othersized documents, change the Original Size option. Referto Scan Options on page 53 for further information.Note: Documents are only scanned once even whenseveral copies are selected.Select the Scan DestinationNote: Some options may be unavailable depending on your machine configuration.Scan to USB1. Load the documents to be scanned either face down on the document glass or face up into theautomatic document feeder.2. Insert a USB Memory Device into the USB memory port on your machine. The USB menuautomatically displays.Note: When in Power Save mode, the machine will not recognize when a USB Memory Device isinserted into the USB port. Press any button to restore the machine to a normal state and reinsertthe USB Memory Device into the port.3. Press the up/down arrows to highlight Scan to USB and press OK.Scan to Local PCTo use Scan to Local PC, the machine must be connected to your PC or workstation via a USB cable. Thescan driver must be installed on your PC prior to use. For instructions, refer to the System AdministratorGuide.1. Press Scan on the control panel.2. Press the up/down arrows to highlight Local PC.3. Press OK. If you see the Not Available message, check the port connection and/or setup.4. Press the up/down arrows until the scan destination you want highlights and press OK.
