Network SettingsXerox WorkCentre 3315DN/3325DN/3325DNIUser Guide178Network SettingsYou may set up the network using the machine's display screen. Before doing that, you must have therelevant information concerning the type of network protocols and computer system you use. If youare not sure which setting to use, contact your System Administrator to configure this machine on thenetwork, or refer to the System Administrator Guide for instructions.1. Press Machine Status on the control panel.2. Press the up/down arrows to highlight Network Settings and press OK. If necessary, enter theAdministrator’s Password using the keypad. Refer to Accessing the Setup Options on page 154 forinstructions.The following Network Settings options and settings are available:3. Press the up/down arrows to highlight the option required and press OK.4. Press the up/down arrows to highlight the setting required and press OK to save the selection.Option Description SettingsTCP/IPv4 Select appropriate protocol and configure parametersto use the network environment.• DHCP *• BOOTP• StaticTCP/IPv6 Select appropriate protocol and configure parametersto use the network environment.• IPv6 Activate *• DHCPv6 ConfigEthernet Speed Configure the network transmission speed. • Automatic *• 10Mbps Half• 10Mbps Full• 100Mbps Half• 100Mbps Full• 1Gbps Full(3325DN/DNI only)802.1x Use to enable 802.1x and CentreWare InternetServices.• On• Off *Wireless(3325DNI only)Use to enable the machine to be configured on awireless network connection.• Wi-Fi ON/OFF• WPS Settings• WLAN Setting• WLAN Default• WLAN SignalClear Settings Reverts the network settings to the default values. • Clear? Yes / NoNetworkConfigurationEnables printing of the Configuration report. • Print? Yes / NoNet Activate Turns access to the Ethernet network on or off. • On *• OffHttp Activate Enables Http on the machine giving access to theembedded web page.• On *• Off
