August 20072-132 WorkCentre 5687 Family05FStatus Indicator RAPs05F Damaged Documents RAPUse this RAP if the documents get damaged by the DADH.ProcedurePerform the steps that follow :1. If the DADH damages the bottom of the documents mid-way along the lead edge, install anew feed roll assembly, PL 5.15 Item 1.2. ADJ 5.2 DADH height adjustment.3. Check the input tray for damage, PL 5.35 Item 1.• Make sure that the document width guides move freely.• Check that the takeaway roll assembly and exit roll assembly, PL 5.35 Item 6 fordamage and contamination, refer to ADJ 5.4.• Check the restack arm for damage, PL 5.35 Item 3.4. Open the DADH top access cover assembly, PL 5.20 Item 17.• Check the document path for damage.• Check the takeaway roll idlers and CVT roll idlers, PL 5.20 Item 3 for damage. Makesure the idlers are clean and rotate freely, refer to ADJ 5.4.5. Raise the DADH. Lower the baffle assembly, Figure 1.• Remove any pieces of paper.• Check the duplex gate, PL 5.25 Item 12 for damage. Make sure the duplex gatemoves freely.• Check the CVT roll, PL 5.25 Item 5 for damage. If necessary, clean the CVT roll,ADJ 5.4.• Check the pre-scan idlers, PL 5.25 Item 6 and post scan idlers, PL 5.30 Item 6 fordamage. Make sure the idlers are clean and rotate freely, refer to ADJ 5.4.• Check the document path for damage.• Check the baffle assembly, PL 5.30 Item 5 for damage.• Check the exit roll idlers for damage, PL 5.30 Item 8. Make sure the idlers are cleanand rotate freely, ADJ 5.4.6. Check the CVT ramp assembly, (32-55 ppm) PL 14.20 Item 13 or (65-87 ppm) PL 14.10Item 13 for damage.7. Make sure that the customers documents are within the specification, refer to GP 20.Figure 1 Component locationPre-scan idlersPost scan idlersBaffle assemblyDuplex gateCVT roll
