August 20072-185WorkCentre 5687 Family 08-100, 08-100AStatus Indicator RAPs08-100 Wait Sensor Jam Entry RAP08-100 The lead edge of the paper failed to actuate the wait sensor within the correct time fromfeed sensor 1.ProcedureIdentify the speed of the machine, refer to SCP 7 Machine features. Perform one of the stepsthat follow:• If the speed of the machine is 35-55 ppm, go to 08-100A Wait Sensor RAP (32-55 ppm)• If the speed of the machine is 65-87 ppm, go to 08-100B Wait Sensor RAP (65-87 ppm).08-100A Wait Sensor Jam RAP (32-55 ppm)08-100 The lead edge of the paper failed to actuate the wait sensor within the correct time fromfeed sensor 1.Initial Actions• Make sure that the correct RAP is used. To identify the correct RAP to use, go to the 08-100 Wait Sensor Jam Entry.• Check the condition of the paper in all trays. Refer to IQ1 and GP 20.• Check for obstructions in the paper path.• Check wait sensor actuator, Figure 1.• Check that the left hand door is latched correctly.• Check that the interlock cover has not come loose. PL 7.30 Item 23. Bias the cover to theright and tighten the two screws.• Make sure the correct paper size is displayed for the size of paper in the tray.ProcedureNOTE: The front door interlock must be cheated when checking +24V components.Enter dC330 code 08-100 wait sensor, Q08-100. Press Start.Manually actuate the wait sensor. The display changes.Y NGo to Flag 1. Check Q08-100. Refer to:• GP 11 How to Check a Sensor.• P/J5, IOT PWB.• 01D +3.3V Distribution RAP.• 01B 0V Distribution RAP.Install new components as necessary:• Wait sensor, (32-55 ppm) PL 8.15 Item 3.• Perform OF7 IOT PWB Diagnostics RAP before a new IOT PWB is installed, PL1.10 Item 2.Enter dC330 code 08-101 tray 1 feed sensor, Q08-101. Press Start. Open left hand door andmanually actuate the sensor. The display changes.Y NGo to Flag 2. Check Q08-101. Refer to:• GP 11 How to Check a Sensor.• P/J276, Tray 1 and 2 control PWB.• 01E +5V Distribution RAP.• 01B 0V Distribution RAP.Install new components as necessary:• Tray 1 feed sensor, PL 7.30 Item 25.• Tray 1 and 2 control PWB, PL 7.10 Item 2.Enter dC330 code 08-025 tray 1 and 2 transport motor, MOT08-025. Press Start. The motorruns.
