August 20072-394 WorkCentre 5687 Family11-043-130Status Indicator RAPs11-043-130 Hole Punch Cycle Failure RAP11-043-130 The hole punch fails to complete a cycle of operation.NOTE: The home position of the punch unit is when the cutout in the actuator is between thepunch head home sensor jaws.Initial Actions• Check that the hole punch is correctly installed. Check for damage or an obstruction thatwould prevent the hole punch from operating. If necessary, install a new punch unit, PL11.36 Item 12.• If the hole punch is not at the home position, check that is not jammed in the punchingposition. This can occur with transparencies and labels. Remove the hole punch and clearany jammed material. Rotate the hole punch unit by hand to check for binding or damage,if necessary, install a new hole punch unit PL 11.36 Item 12.• Check for damage to the hole punch motor coupling, PL 11.36 Item 11.ProcedureNOTE: All HCSS interlocks must be made to supply +24V to the motors.Enter dC330, codes 11-043 punch head run, then 11-042 punch head move home. Figure 1.The punch cycles, then goes to the home position.Y NGo to Flag 3. Check the hole punch motor, MOT11-042.Refer to:• GP 10, How to Check a Motor.• P/J421, HCSS PWB.• 11C-130 HCSS Power Distribution RAP.Install new components as necessary:• Hole punch motor, PL 11.38 Item 7.• HCSS PWB, PL 11.56 Item 5.Enter dC330, code 11-110. Actuate the punch position sensor, Q11-110, Figure 1. The dis-play changes.Y NGo to Flag 1. Check the sensor, Q11-110.Refer to:• GP 11, How to Check a Sensor.• P/J420, HCSS PWB.• 11C-130 HCSS Power Distribution RAP.Install new components as necessary:• Punch position sensor, PL 11.38 Item 9.• HCSS PWB, PL 11.56 Item 5.Enter dC330, code 11-350. Actuate the hole punch home sensor, Q11-350, Figure 1 The dis-play changes.Y NGo to Flag 2. Check the sensor, Q11-350.Refer to:• GP 11, How to Check a Sensor.• P/J420, HCSS PWB.• 11C-130 HCSS Power Distribution RAP.Install new components as necessary:• Hole punch home sensor, PL 11.38 Item 8.• HCSS PWB, PL 11.56 Item 5.Perform SCP 6 Final Actions.Figure 1 Component locationPunch positionsensor, Q11-110Hole punch home sensor,Q11-350Hole punch motor, MOT11-042AA
