ENGINE3-135. Drain:• Engine oil(completely from the crankcase)6. If the oil filter cartridge is also to bereplaced, perform the following procedure.▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼a. Remove the oil filter cartridge “1” with an oilfilter wrench “2”.b. Lubricate the O-ring “3” of the new oil filtercartridge with a thin coat of engine oil.CAUTION:ECA13390Make sure the O-ring “3” is positioned cor-rectly in the groove of the oil filter car-tridge.c. Tighten the new oil filter cartridge to speci-fication with an oil filter wrench.▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲7. Check:• Engine oil drain bolt gasket8. Install:• Engine oil drain bolt(along with the gasket)9. Fill:• Crankcase(with the specified amount of the recom-mended engine oil)10. Install:• Engine oil filler cap• Lower cowlingsRefer to "GENERAL CHASSIS" on page 4-1.11. Start the engine, warm it up for severalminutes, and then turn it off.12. Check:• Engine(for engine oil leaks)13. Check:• Engine oil levelRefer to "CHECKING THE ENGINE OILLEVEL" on page 3-12.EAS20820MEASURING THE ENGINE OIL PRESSURE1. Check:• Engine oil levelBelow the minimum level mark ”a” → Addthe recommended engine oil to the properlevel.Oil filter wrench90890-01426YU-38411Oil filter cartridge17 Nm (1.7 m·kg, 12 ft·lb)Engine oil drain bolt43 Nm (4.3 m·kg, 31 ft·lb)Engine oil quantityTotal amount3.83 L (4.05 US qt) (3.37Imp.qt)Without oil filter cartridgereplacement2.90 L (3.07 US qt) (2.55Imp.qt)With oil filter cartridge replace-ment3.10 L (3.28 US qt) (2.73Imp.qt)NewManuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keysemail: info@motomatrix.co.uk