Yamaha YZF-R1 2007 Service Manual

CLUTCH5-52NOTE:Assemble the friction plates and clutch platesaccording to the installation order.7. Install:• Friction plate 1 “1”NOTE:Install the last friction plate shifting half phasewith the ø2 punch mark “2”.8. Install:• Bearing• Pull rod• Pressure plate 1 “1”9. Install:• Clutch springs• Clutch spring bolts “1”NOTE:Tighten the clutch spring bolts in stages and ina crisscross pattern.10. Install:• Push leverNOTE:Install the push lever with the “h” mark facingtoward upper side.11. Install:• Clutch cover• Clutch cover gasketNOTE:• Install the push rod so that the teeth a facetowards the rear of the vehicle. Then, installthe clutch cover.• Apply oil onto the bearing.• Apply molybdenum disulfide grease onto thepush rod.• When installing the clutch cover, push thepush lever and check that the punch mark “a”on the push lever aligns with the mark “b” onthe clutch cover. Make sure that the push rodteeth and push lever shaft pinion gear areengaged.Clutch spring bolt10 Nm (1.0 m·kg, 7.2 ft·lb)Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keysemail: info@motomatrix.co.uk