FRONT BRAKE4-26d. Measure the brake disc deflection.e. If out of specification, repeat the adjust-ment steps until the brake disc deflection iswithin specification.f. If the brake disc deflection cannot bebrought within specification, replace thebrake disc.▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲6. Install:• Front wheelRefer to "FRONT WHEEL" on page 4-8.EAS22260REPLACING THE FRONT BRAKE PADSNOTE:When replacing the brake pads, it is not neces-sary to disconnect the brake hose or disas-semble the brake caliper.1. Remove:• Brake hose holder “1”• Brake caliper “2”2. Remove:• Brake pad clips “1”• Brake pad pins “2”• Brake pad springs “3”3. Remove:• Brake pads “1”4. Measure:• Brake pad wear limit “a”Out of specification → Replace the brakepads as a set.5. Install:• Brake pads• Brake pad springFront brake disc bolt18 Nm (1.8 m·kg, 13 ft·lb)LOCTITE®Brake pad lining thickness(inner)4.5 mm (0.18 in)Limit0.8 mm (0.03 in)Brake pad lining thickness(outer)4.5 mm (0.18 in)Limit0.8 mm (0.03 in)Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keysemail: info@motomatrix.co.uk