Yamaha YZF-R1 2007 Service Manual

CABLE ROUTING2-501. Starter relay lead2. Starter motor lead3. Battery positive lead4. Lean angle sensor5. Turn signal/hazard relay6. Main fuse7. Turn signal light/license plate light lead8. Tail/brake light lead9. Tail/brake light bracket10.Lower tail cover11.Seat lock cable12.Anti safety alarm coupler13.Starting circuit cut-off relay14.Battery negative lead15.Starter relay16.Rear frame17.Rear arm bracket18.Wire harness19.Battery box 120.Battery21.ECU (engine control unit)22.Cover23.Battery box 224.License plate light lead25.Turn signal light lead26.Mud guardA. Point the tip of the clamp (excessive part)to the inner down side of the vehicle andclamp at the junction of the wire harness.Fasten the battery negative lead, wire har-ness and starter motor lead with a clamp.B. Point the tip of the clamp (excessive part)to the inside of the vehicle.Fasten the wire harness with a clamp.C. Hold down the clamp tips after passingeach lead.D. Insert the leads to the rear frame hole.E. Insert the clamp from the vehicle front tothe rear side and fasten each leads, cou-pler and onionhead to the tail/brake lightbracket, and then point the tip of the clamp(excessive part) to the lower front side ofthe vehicle.F. It should be set in the rear frame not to becaught in the sheet bottom or the covers.G. Pass the battery negative lead throughinside of the battery band.H. Battery negative lead should not run on therear arm bracket.I. All leads should be positioned lower thanthe tail/brake light bracket.Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keysemail: info@motomatrix.co.uk