11-12 FRX8000 3.0 User Guide, Rev 02Configuring SDLC PUsSLDC PU configuration falls into one of three categories:l FRX8000 HPAD and TPAD PUsl N7000 HPAD PUsl N7000 TPAD PUsHPAD PU configuration in both FRX8000 and N7000 defines the TPADs that willcommunicate with each HPAD. TPAD PU configuration defines the remote devicesthat will connect to each TPAD.On an N7000 SNA port, the first HPAD/TPAD is defined in the Port file,and the PU file is used to define any additional TPADs/PUs.You are required to enter subscriber IDs when creating PU records. If aSubscriber record has not been created for one of these IDs, you will seeNo match in Database when you enter its ID. This is OK as long as youcreate the record before attempting to initiate HPAD-TPAD communi-cation.Press [F] at the Ports Selection Menu (or [A], [D], [F] from the Main Menu) to displaythe SNA PAD Management Menu. From there:l To configure an N7000 HPAD PU, press [A], then [C].l To configure an N7000 TPAD PU, press [B], then [C] .l To configure an FRX8000 HPAD or TPAD PU, press [C] twice.When prompted, enter:l Node ID (of the node containing the SNA port): 1–250. (Default is the “local”node.)l LP ID (of the LP containing the port): 0–7. (Default is 0.)l Port: 0–7 for a port on an RLP, 0–3 for a port on an AST LP (N7400/7500 only).l FRX8000 only – SDLC Station Address: 0–ff (Default is c1.)l N7000 only – PU Number: 1–31. (Default is 1.) (PU 0 is defined in the Portrecord.)l Any other requested information, noting the values in Table 11-3. (Press [Enter]at a prompt to specify the default value.)The display will depend on whether the SNA PAD is an N7000 HPAD (Figure 11-5),N7000 TPAD (Figure 11-6), or FRX8000 PAD of either type (Figure 11-7).
