Configuring Async Pads 13-17Configuring Subscriber IDsThis operation creates records for the called and calling addresses that will be used inX.25 call setup if async traffic will be transported over X.25 or (via an X.25 logicalport) frame relay. To complete the connection, the software must recognize where thecall is coming from (calling address) and where it is going (called address).To configure an SVC Subscriber record, press [A], then [C] at the Subscriber Config-uration Menu (or [A], [F], [A], [C] from the Main Menu). When prompted, enter aSubscriber ID, up to 15 digits (as described on page 9-15). (The default is an asterisk,a universal wildcard.) If this is an existing record, a screen similar to Figure 13-4 willbe displayed. If this is a new record, enter the remaining requested information, notingthe values in Table 13-4.Figure 13-4 SVC Subscriber Record[A], [F], [A], [C] from Main MenuThe parameters displayed by pressing [1] or [2] are listed in Table 13-4.When Changes Take EffectWhen you add a new Subscriber record, the change will be written to the database assoon as you enter the final parameter value. When you modify a parameter in anexisting record, the change will be written to the database immediately.The change will become effective as soon as the next call is placed. (The change willnot affect a call in progress.)Su bscrib er Maintenance* S ubs criber ID 10000100001A S ubs criber Name frs ub1B D ialup S ubs criber NC R outing Algorithm 0 R ound Rob inD S ystematic R ed irection YE R ed irect on Busy NF R ed irect on Ou t of Order NG Ban dw. A llocation Grou p 11 R outing Paths2 R ed irection Add ress esSelect:
