Configuring Node Records 5-3Figure 5-3 N7000 Node Record[A],[B],[A],[C] from Main MenuItem E is displayed only if Node Type is 1 or 3.Item N is displayed only if Node Type is 0 or 1.Item O is displayed only if Node Type is 1.The text following each node’s ID at items B and E–M is theDescription in that node’s Node record.When Changes Take EffectWhen you add a Node record, the change will be written to the database when youenter the final parameter value. When you modify a parameter in an existing record,the change will be written to the database immediately.Changes to the following parameters can be implemented without disrupting nodeoperation:l Alternate NMP Node, described in the explanations following Table 5-1.l Level “n” Primary/Secondary Node, described under “Changing Alarm RoutingOn Line” on page 4.A change to any other parameter will take effect after the next IPL of the configurednode, with the exception of Node Type, which must be implemented (assuming thenecessary changes have been made at the node to add/remove system board memoryand UNIX and FRX8000 software) by performing a Configuration Update in Boot DiskDownload Operations ([B], [B], [D], [D] from the Main Menu—described on page 18-6).N ode Main ten ance* Node I D 100A Description ABCB Alternate N MP Node 10 D EFC 7000 Nod e? YD Node Typ e 1 D OS n odeE 2nd Alternate NMP Node 11 GHIF Level 1 Primary Node 10 D EFG Level 1 Secon dary Nod e 11 GHIH Level 2 Primary Node 10 D EFI Level 2 Secon dary Nod e 11 GHIJ Level 3 Primary Node 10 D EFK Level 3 Secon dary Nod e 11 GHIL Level 4 Primary Node 10 D EFM Level 4 Secon dary Nod e 11 GHIN Asyn c Terminal C ontrol NO Dos Exten ded Mod e? NS elect:
