G-6 FRX8000 3.0 User Guide, Rev 029. Messages will be displayed, ending with:** Safe to Power Off **- or -**Press any key to Reboot**10. Switch the unit off.Rebooting an INMTo reboot an FRX8000 INM:1. The first step depends on the display:u If the FRX8000 Test Menu (or one of its sub-menus) is displayed, go tostep 2.u If the Main Menu (or one of its sub-menus) is displayed, press [F1] , then goto step 2.2. Press [C] at the FRX8000 Test Menu.3. When prompted: Reboot (R to reboot, T to terminate), press [R].FRX8000 NMPStarting an NMP1. Switch on the VGA monitor or Auxiliary Console (and modems if part of the con-figuration), then the printer (if present), then the NMP. After a few seconds, thiswill be displayed on the monitor/console:SCO System V/386Boot:2. Press [Enter]. (If any files are corrupted because the system was not shut downproperly, error messages will be displayed. Press [Enter] if requested to do so.)3. You will be prompted:Type Control-D to proceed with normal startup(or give root password for system maintenance)Press (simultaneously) [Ctrl] [D].4. The current system date and time will be displayed. Press [Enter] to accept the dis-played values, or enter the correct values, in the format: YYMMDDhhmm, where:YY = year (00 to 99) MM = month (01 to 12 ) DD = day (01 to 31)hh = hour (00 to 23) mm = minute (00 to 59)If you only need to change the time, enter the hour and minute; to change the year,month, or day, you must enter the entire string, including hour and minute.5. Various messages will be displayed, ending with: Check protected subsystemdatabase (y/n)? Type y [Enter] .6. scosysv!login: will be displayed. Type netlink [Enter].7. When asked for a password, type mypass [Enter].
